Sista Polyurethane Assembly Foam 750 ml

DESCRIPTION

Moisture curing polyurethane foam

APPLICATION AREAS

It is a universal multi-purpose material that can be used for fixing door and window frames to the wall and filling the gaps in these areas, for coating and insulating hot and cold water pipes, for fitting bathtubs to the floor and for all kinds of joints and dilation joints that can be imagined. The material can be used for bonding, filling and insulation purposes. It provides adhesion to all building elements except polyethylene, polyproplene, silicone and teflon.

PRODUCT ADVANTAGES

Will not lose volume, collapse or deteriorate (registered patent EPO066830)

Cuttable, plasterable, paintable

Resistant against water

Non-toxic when dried

Ready to use, one component

Cures with moisture

Does not damage the ozone layer

Cures fast.

No expansion after solidification

APPLICATION

Shake the can vigorously about 20-25 times to homogenize the material.

Moisten the application surface with water.

The box should be turned upside down and tightened at an angle of approximately 45°C.

Dosage can be adjusted by trigger.

Since the foam will swell, the gaps should be filled sparingly.

Surfaces should be clean and absorbent. Concrete floors should be only slightly dampened.

In the fitting of the door frames, wedges should be stretched from the inside to prevent the foam from stretching the wood.

Suitable joint spacing of door frames is 2 cm. The dried foam can be easily cut with any knife, anything can be glued on and painted.