WD 40 Smart Straw Rust Remover Lubricant 350 ml

GENERAL PURPOSE LUBRICATION SPRAY AND RUST REMOVER

APPLICATION AREAS

● Thanks to the high attraction to metal in the WD-40 formula, WD-40 is able to protect surfaces even under humid conditions

completely covers. Even when sprayed, brushed or dipped, the metal surface and moisture

and forms a protective layer. With this feature, WD-40 immediately eliminates moisture-related short circuits

is very useful in situations where electrical contact is involved, as it eliminates the need for electrical contact.

● WD-40 penetrates rusty and corroded surfaces with its metal-attracting properties, making it an effective rust remover for metal,

wire removes rust from ropes, stuck nuts, connections, control mechanisms and other metal parts

eliminates corrosion, allowing parts to work freely.

● WD-40 spreads completely on metal surfaces, covering even microscopic pores. This layer and the moisture of WD-40

Provides protection against moisture and other rust-forming substances on metal surfaces thanks to its protective formula.

If the metal is used regularly, the protection will continue.

● WD-40 formula contains no abrasives and removes very thick layers of grease and dirt, labels and adhesives

cleans material residues completely from the surface. In addition, it forms a film layer against decay and rust

protects.

● Thanks to WD-40's high gravity, the lubricants in its content spread over the entire surface and move

provides excellent adhesion to parts. WD-40 silicone or any other dust and dirt collecting additive

since it does not contain any substance, it does not form a dirt layer on the surface.

TECHNICAL SPECIFICATIONS

● Appearance: Clear and slightly cloudy

● Odor: Very light, characteristic, pleasant odor

● Specific gravity: 800 ± 0.020 at 22°C

● Viscosity: 27.5 ± 1.0 sec zahn 1 at 22°C

● Minimum flash point: 43°C in open container

● Pour point: Less than -73°C

●● Low heat stability: Excellent

● Coverage: 15 m2 - 26 m2/liter

● Boiling point: 149°C minimum

● Applied coating: 1.7 g/m2

● Applied product thickness: 0.00025 - 0.00075 cm