Socket Pendant Snap-in 63x1/2

+   In bolted socket necklaces  bolts should be tightened enough to ensure tightness during assembly.

+  If there is a dimensional difference in the pipe greater than the standard value  (> 0.5 mm), the upper and lower covers will not touch each other in the socket necklace assembly. In this case; it is not necessary to tighten the bolts of the bolted socket pendants until the upper and lower covers touch each other, and the wedges of the plug-in socket pendants do not need to be driven in until the end. Otherwise, excessive stress will occur on the product. This will affect the life of your installation and may cause the dimensions of the product to change. Especially the size change in the threaded part may prevent the installation of the male threaded adapter to be mounted on the socket necklace.

+   When assembling the socket pendants, the wedges or bolts must be installed opposite each other. If a wedge is driven in completely or a bolt is tightened completely, an excessive force is generated on one side of the material and this force may cause the product to break.

+  Made of impact resistant, high quality polypropylene raw material.

+  It is designed to prevent leaks  that may arise from dimensional differences in pipes up to ±0.5 mm.

+  Oring is made of natural rubber and provides high sealing.

+  Does not contain any foreign substances that can change the smell and taste of water.